You would think sitting all day would be relaxing and feel good.  That usually isn’t the way it goes.  You can make it as good as possible by making sure your workstation is set up correctly.  As your chiropractor in the Woodbridge, Dale City VA area I would suggest you follow the instructions below and not use my set up as your guide.

The first step in setting up an office chair is to establish the desired height of the individual’s desk or workstation. This decision is determined primarily by the type of work to be done and by the height of the person using the office chair. The height of the desk or workstation itself can vary greatly and will require different positioning of the office chair, or a different type of ergonomic chair altogether.

Once the workstation has been situated, then the user can adjust the office chair according to his or her physical proportions. Here are the most important guidelines – distilled into a quick checklist – to help make sure that the office chair and work area are as comfortable as possible and will cause the least amount of stress to the spine:

Elbow measure

First, begin by sitting comfortably as close as possible to your desk so that your upper arms are parallel to your spine. Rest your hands on your work surface (e.g. desktop, computer keyboard). If your elbows are not at a 90-degree angle, adjust your office chair height either up or down.

Thigh measure

Check that you can easily slide your fingers under your thigh at the leading edge of the office chair. If it is too tight, you need to prop your feet up with an adjustable footrest. If you are unusually tall and there is more than a finger width between your thigh and the chair, you need to raise the desk or work surface so that you can raise the height of your office chair.

Calf measure

With your bottom pushed against the chair back, try to pass your clenched fist between the back of your calf and the front of your office chair. If you can’t do that easily, then the office chair is too deep. You will need to adjust the backrest forward, insert a low back support (such as a lumbar support cushion, a pillow or rolled up towel), or get a new office chair.

Low back support

Your bottom should be pressed against the back of your chair, and there should be a cushion that causes your lower back to arch slightly so that you don’t slump forward or slouch down in the chair as you tire over time. This low back support in the office chair is essential to minimize the load (strain) on your back. Never slump or slouch forward in the office chair, as that places extra stress on the structures in the low back, and in particular, on the lumbar discs.

Resting eye level

Close your eyes while sitting comfortably with your head facing forward. Slowly open your eyes. Your gaze should be aimed at the center of your computer screen. If your computer screen is higher or lower than your gaze, you need to either raise or lower it to reduce strain on the upper spine.

Armrest

Adjust the armrest of the office chair so that it just slightly lifts your arms at the shoulders. Use of an armrest on your office chair is important to take some of the strain off your upper spine and shoulders, and it should make you less likely to slouch forward in your chair.

 

+scottdoroski3122/posts

+doroskichiropractic3122/posts

 

Doroski Chiropractic Neurology

3122 Golansky Blvd, Ste 102

Woodbridge VA 22192

703 730 9588

 

Maplink